2024-02-23

Inside the Particulate Monitor – the Triboelectric Method

The triboelectric measurement principle (in a refined design referred to as Inductive Electrification Technology) can be used to measure dust concentrations in industrial processes. It is based on the dust particles becoming electrically charged as they move through the flue gas duct. The charges are picked up by an insulated probe inside the duct and then registered.

Electrical Characteristics

When the particles come in contact with or close to the probe, they transfer their charges to the probe. The received charges are then amplified and converted into a signal which consists of two components. A DC component originate from particles coming in direct contact with the sensor (traditional triboelectric signal), and an AC component is generated by particles coming into contact as well as passing nearby the probe. In either case, the resulting electrical charge signal from the probe is then converted into a dust concentration reading by applying a calibration factor.

The operating principle of a triboelectric dust monitor.

Dependencies

The triboelectric method depends on the electrostatic properties of the dust particles, i.e. ability to carry a charge, as well as changes in the charges through e.g. electrostatic particle filters. These factors can be hard to estimate, and they can also vary widely in a running industrial process. Historically, the triboelectric method has therefore mainly been used for indicative measurements. However, development of advanced algorithms analysing the signal utilizing the inductive electrification technology can nowadays provide very accurate dust concentration measurements.

Author

Bengt Löfstedt
OPSIS AB

Articles

2022-03-29

Air Quality Monitoring in the EU – What, Where, and How?

Air quality is essential to all of us, and consequently, so is the monitoring of air quality. However, what should be monitored, and where, and how? There are many bids on that. For example, the European Union has set minimum requirements on the surveillance of the air we breathe. Let’s have a closer look!

2022-03-23

New European BAT Conclusions for Waste Incineration – it’s Time to Monitor Total Mercury

The European Union has decided on new monitoring requirements and new emissions limits for waste incineration facilities. This applies to pollutants such as total mercury (THg) and dioxin. Continue reading to find out what it’s all about.

2021-04-08

Inside the Gas Analyser – the Tuneable Diode Laser

OPSIS is probably best known for its gas analyser systems based on broad-band (“white”) light from xenon lamps and spectrometers or interferometers as the core analysis devices. However, OPSIS also offers an instrument type base on a quite different optical technique – light absorption detected by utilizing a tuneable diode laser. Let’s take a closer look!

2021-03-16

Inside the Gas Analyser – the Interferometer

Some OPSIS gas analysers are based on a device called an interferometer. Like a spectrometer, it separates light into its wavelength components, but it’s done in a special and indirect way. Keep on reading to find out how!

2021-02-23

Inside the Gas Analyser – the Spectrometer

Several of OPSIS gas analyser types are based on a device called a spectrometer. It separates light into its wavelength components, allowing the analyser to detect light absorption and thereby determine gas concentrations. Let’s take a closer look at how a spectrometer works!